A table saw can be used to create custom wood projects, or to cut large pieces of wood in precise measurements. Tools like table saws and chainsaws are also available. Drills are also popular tools as they can sharply drill holes and turn screws, and they come in different sizes and designs to fit any need. ![]() ![]() A toolbox is the starting point for every home improvement project, with an assortment of hand tools, power tools, and accessories designed to fit in compact spaces. Just put the rivet in, align the steel block with the rivet head, and squeeze, keeping an eye on both jaws".Īlso see article BD-108B in the Body section.At, you will find wholesale split rivet tool for various applications. I drilled a depression into a small square steel piece with a 5/8" bit to act as a locator for the rivet head, and welded that to the other jaw of the Vice-Grip. I drilled two 1/4" holes, 1/4" apart in a piece of 1/4" bar, and split the piece just to one side of center, and welded it to the Vice-Grip. "I wound up making one using some 1/4" steel stock and an old pair of Vice-Grip I had lying around. On Apr 18, 2015, Alan Wiedie in Bolton, CT, USA wrote: The top piece that goes into the arbor was a Hex bit that will accept the Modified hex bit I made". Then I got my arbor press and drilled a 3/16 hole in the base and the arbor to be able to accept the Aircraft rivet dies. After it was all welded together I put it into the drill press and with a file made it look pretty. The blade inside the nut gave me a good working platform to use a Dremel and make the curves that will fold over the rivet. Then slid the nut on the bit and welded it all together. Then got a 5/16 nut and drilled it out to the size of the bit. "I started with a flat blade screw driver Hex bit that fits in a cordless drill. The hex tail can be held in a standard bit holder in the arbor press. This is made from a screwdriver bit and a hex nut welded together, then ground down to the appropriate punch shape. Here's another one from Ron Bissland in Kenosha, WI, USA. Photos below have it the right way around. The round head should seat against the rubber, while the formed ends seat against the metal panel. Notice the rivet shown is wrong end around. I found if you pry them just enough to ensure they split instead of getting smashed together it puts a very nice curl in them". One trick I learned was not to split the legs too far apart when you start. I was pretty hesitant on the first one, but finally ended up beating the snot out of it and got it looking much better than the photo below. I had read that the tangs on the split rivets are supposed to be curved so I built myself a tool to set them properly by grinding down the head of a lag bolt. On, Larry Wheeler in Hillsboro, OR, USA wrote: If you want to buy a hand tool to do this job, see here: Voila! (I learned a big lesson right there)".įor as long as it may remain posted, you can view a short YouTube video on how the split rivet works. Then I tried putting the rivet into a piece of rubber. ![]() "When I frst tried the tool I did not support the rivet, just had it on a piece of steel. I ground the 2 groves with my Dremel, using a cylindrical stone a bit less than 1/4 inch diameter". It is 1/2 inch diameter, although anything close would work. "Here's a simple setting tool for split rivets. ![]() Jack Wannenwetsch near Rochester, New York, USA wrote: SPLIT RIVET Setting Tool The MGA With An Attitude
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |